wiring SCN6

[Baptx]

What I can do?
Lots of kisses?

[Baptx]

hello, I come to you because you have given me invaluable.

I finished SCN6 cable everything is ok, but X-sim does not detect there is a procedure to do for aditional SCN6 compared to SCN5?

Thank you in advance

[sirnoname]

Enable debug mode, tell us the message as written in the two SCN posts.

[Baptx]

A big thank you to sirnoname takes time for me!

I just no message that appears ...
I wired two 24v and two 0V (Control and driver)
For converters is the same as for the wiring scn5
I am plugged into a 5A power

Thank you for your help

[sirnoname]

In debug mode it is not possible that there are no messages.

[Baptx]

then these are the messages.

http://www.casimages.com/i/140330101451438167.png

http://www.casimages.com/i/140330101453724148.png

[Baptx]

I accepted two messages and it works ...

Thank you for your ade sirnoname REALLY!

[sirnoname]

Your posts have absolutely nothing to do with SCN. You did make pictures from the extractor but the SCN are controlled by the converter software. You do not need the extractor for checking SCN wiring.