wiring SCN6

[Baptx]

Hi guys!

I am trying to make a simulator 3 dof,with two cylinders SCN5 and a SCN6 I finished wiring jacks SCN5 but I can not find a diagram for wiring SCN6, which is not the same.

Thank you in advance

sportingly

[sirnoname]

Why you can't?
Project Gallery -> Controller and drivers -> SCN5 / SCN6 -> Hardware Thread

viewtopic.php?p=255#p255

[Baptx]

Ok thank you for your help, I had already seen this topic but .....

For SCN5 we need 3 son: 24V / 0V and ILK
For SCN6 if I understand you must supply 5 son? 2x 24V / 0V 2x / 1X ILK?

Thank you for your help, thank you

Sorry for spelling mistakes I'm french

[sirnoname]

More power = more cable diameter.
For a first test you can simple connect three wires.

[Baptx]

Ok thank you very much for your help

If I plug that 3 son, which I take:
24V Drive with 0V drive
or
24V control with 0V control

By cons however is to have more power?
The actuator will then move all the structure of the simulator so you need power what do you think?

[Baptx]

welcome back
I finished the wiring jacks SCN5 and voila the message that I have.

http://nsa33.casimages.com/img/2014/03/21/140321102231620595.png
Thank you for yout help

[sirnoname]

As the message tell you. As written here some SCN may have GND on ilk instead of 24V.

[Baptx]

The ILK is good on 24V

[sirnoname]

Did you try GND?

[Baptx]

OMG thank you !!!!!!!!!!!!!!

it works