Rotary Stewart Platform v2

by **sanmarcelllo** » Tue 17. Jun 2014, 17:33

Good afternoon everyone,

I can use x-sim with this configuration (Stepper motors, plate and rumba our arduino mega 2560 e etc.)?

https://www.marginallyclever.com/shop/s ... latform-v2

thank you

by **telfel** » Wed 18. Jun 2014, 13:20

Hi

Can I ask what you are going to use it for? as most on here tend to use RC servo's

regards Terry

by **sanmarcelllo** » Wed 18. Jun 2014, 14:35

Hi

I will use with stepper motor and gear, as end of travel sensor.

Thank you.