Arduino 2DOF Simulator motor control problem solved with post #23723

[nevendary]

Hello,

I have built a 2DOF simulator seat and only thing left is getting up and running wiper motors which i have connected with potentiometers. The thing is i used code and components from already done project, but the motors do not work right.

For example when pot value is lower than about 400-500 it just stops working what ever it is supposed to do. Also it ignores maximum value where it should stop. Altough pot readings are corresponding to code.

This is the project link:

viewtopic.php?f=37&t=943

I also tried this with same problems:

https://www.instructables.com/id/Wiper- ... ega-Servo/

I would really appreciate anyones help

Thanks in advance!

[RacingMat]

please post pictures of your electronic board, your motor and pot!

[nevendary]

IMG_20190822_121145.jpg (3.6 MiB) Viewed 5078 times

The grey wire is not connected to anything at this moment. Sorry for bad way to connect stuff, i just had no other option at that moment. I already ordered some terminal connectors and such.

IMG_20190822_121055.jpg (3.38 MiB) Viewed 5078 times

IMG_20190822_121026.jpg (2.98 MiB) Viewed 5078 times

[nevendary]

Any advice please?

[nevendary]

Solved it! It was faulty Monster Moto shield.. switched it and works.

[poojamehta]

Great Information.Thank You