Default value on output pin

[Wanegain]

Hello,

I am using a K8061 with sabertooth 2x12 and wiper motor combined with potentiometers.

When starting and closing Converter, the default value on outputs is 0%, in my case this mean full speed in negative direction !
If I forgot to shutdown my motors (before starting and quitting Converter) they will turn non stop and I have to calibrate the potentiometers...

Is there a way to set output value to 50% by default when starting and leaving Converter or would it possible to include this function in next update ?
Or maybe someone has an idea to prevent this (I am using a single switch to supply the sabertooth) ?

I hope I have been understood

Thanks a lot !

[prodigy]

There is the same problem with K8055, as far as I remember I also had to do shut down the motors before starting Converter. Sometimes the board got disconnected during the gameplay and motors would went full mental But thank godness for the emergency button, was no harm done

[Wanegain]

Maybe the possibility to save this value by default would be great !

I never got this issue concerning the disconnection of the board. It occurs often ?