Anyone used DELTA PLC to communicate with PC? solved with post #19305

[emrekonak]

Hi all,

I want to move a simple plane cockpit via 2 axis.
I have Delta PLC and i can drive stepper motors.
but im not experienced about communication protocols.

Is there anyone used PLC to communicate with converter?

If not, i plan to use arduino to communicate (because comm prog is available) then i connect it to PLC.

Thank you for any advice in advance

Emre

[sirnoname]

For sure not. A DIY community must make it available for all members. That is where a arduino is the best.
However, there is a universal serial output (USO) where you can send any format with a type of RS232 or over network.
http://www.x-sim.de/manual/uso.html

[emrekonak]

Thank you very much for your reply.
I love arduino as well, so i will be using Arduino and share here what i did.

Best wishes!

E.

For sure not. A DIY community must make it available for all members. That is where a arduino is the best.
However, there is a universal serial output (USO) where you can send any format with a type of RS232 or over network.
http://www.x-sim.de/manual/uso.html