My 2DOF simulator with sew eurodrive geared motors

[kermit]

Hi,
I`m waiting on my Amc 1.6 to come with the mail from brasil acc to usmail its already in the Netherlands,
as for hobbypcb Ì already send the file and request,nearly 2 weeks ago, butt still waiting for a reply.
regards

[kermit]

Hi AMC 1.6 arrived,
And a 0-10 volt ez pcb is nearly fininshed,
Not sure how to make a board driving the rotation sens (p1d1 p1d2 etc) from 0 5 Volt to 0 24 volt and how its is connected/powered (if needed0.
I`m looking for a diagram how to connect all the boards and wires to the Ac motors , frequenty inverters and AMC
Also where can I find a complete overview for all the connectors for the Amc 1.6
regards Henk

[vicpopo]

Hi,

Attached an example of wiring diagram for SEW motors and inverter with amc1.6 and my extension board.

Good reading !

cablage.pdf

Connecting diagram

(2.31 MiB) Downloaded 1234 times

Regards

[kermit]

Hi Vic,
thanks for sharing , I have already read it , just one question ,
I have someone to build me the 0-10 EZ board based on AMC 1.5 , but your drawing has a Adaptateur 0-10V / 5-24V
Can you give me a partlist and drawing to build me a Adaptateur 0-10V / 5-24V (cant find the files)
or are these 2 the same?
regards Henk

[vicpopo]

Hi Kermit ,

No there aren't the same ! I will post the extension board on the first post from this topic soon.

Just finished to upload the files at the beginning of this post, here:

http://www.x-sim.de/forum/viewtopic.php?f=37&t=293#p2058

Regards

[kermit]

Hi , thanks for the info, But how can I open the drl and tci files ,
I`m looking for the material file ,
please, is it possible to make me one ?
regards Henk

[vicpopo]

Hi , thanks for the info, But how can I open the drl and tci files ,
I`m looking for the material file ,
please, is it possible to make me one ?
regards Henk

Hi ,

Look here for the soft to open the file.tci.

http://b.urbani.free.fr/pagetci/tci.htm

But you can use the pdf file for making the pcb.Choose a pcb handler and you can send to him the pdf file and the .drl file.
Normally that is enough for making the pcb.

Regards

[kermit]

Hi, the adapteur will be finished this Saterday,
thanks for the files , In the pictures you have a 24 volt PSU but I can`t find the amps of the PSU,
Will 2 amps be enough? I have one from an old siemens plc module systeem
regards Henk

[vicpopo]

Hi ,

No problem 2A is enough!

Regards

[vicpopo]

Hi kermit,

You should open a thread about your project.
It would be better for all , you and people who could help you.
Thanks