SCN5 / SCN6 Software Thread

[mino74]

mr sirnoname
sorry about that but i am doing my best if you show me screen shot how to do it that will be helpfull my computer is in french and you asking for something i do for the first time ever

regards

[sirnoname]

Also post the informations about your adapter. Internal loopbacks are written down in the manual.
You must not be sorry, you have all the time you need. Step by Step.

[mino74]

Doc6.docx

(176.93 KiB) Downloaded 882 times

ok then i think this is what you want !!!

[mino74]

my adaptor is usb-rs485 DEVANTECH how and where we can get more infos.?

[mino74]

ok
i have to re start all over again the wiring of actuators snc5 150 mm 2 wires from snc5 to usb rs485 THE BLACK ONE NOT WIRED ? ok.?

my ilk color is gray is it right or i have to wire the brown one as shown on mirai wiring ?

START CONVERTER FIRST OR EXTRACTOR FIRST ?

[mino74]

Doc7.docx

(320.6 KiB) Downloaded 910 times

this is only what the converter find all the time

[mino74]

Doc8.docx

(168.26 KiB) Downloaded 867 times

this what shown when trying to scan hard disk via converter

[sirnoname]

I talked about this one:
http://www.serial-port-monitor.com/
But your find is very interesting
The screenshot is correct, but I need a view from Receive to Transmit.
Post your adapter infos.

[mino74]

Doc9.docx

(472.7 KiB) Downloaded 887 times

IS this the right way to enable debugmode for snc5 .?

and i am running windows 7 is the link you send is usefull .?

and the check the screen shot is it the right way to enable debug mode or i have to do something else ?

[sirnoname]

Debugmode must be set to 1 (see picture).
I think you do not need the debug mode anymore because we know the error. Set it to 0.

Win7 32 bit should work with the serial port monitor.

Send me your adapter manual or buy link.