Tutorial Dash board Arduino RGB Leds LC (low cost)

[haraguchi]

I made a RGB LEDS as simhub software with low cost taking advantage of a 3 1/4 "drive cover.
I'll use it in my 2dof simulator I'm making.
Materials:
Arduino Uno
2 RGB Leds card
50cm microphone wire
Old computer plate of 3 1/2" drive

Wiring:

Wiring.jpg (120.49 KiB) Viewed 10514 times

Using the front cover of a 3 1/2" drive from an old enclosure:

IMG_1953.JPG (138.41 KiB) Viewed 10514 times

IMG_1954.JPG (130.51 KiB) Viewed 10514 times

Two RGB LEDS cards will be installed behind the cover:

IMG_1955.JPG (129.46 KiB) Viewed 10514 times

Using a crepe tape we mark the points where the holes will be made:

IMG_1956.JPG (187.85 KiB) Viewed 10514 times

IMG_1957.JPG (186.83 KiB) Viewed 10514 times

IMG_1961.JPG (200.35 KiB) Viewed 10514 times

IMG_1963.JPG (135.49 KiB) Viewed 10514 times

Finish using a sandpaper and a small drill to make sure the two plates fit snugly:

IMG_1964.JPG (221.28 KiB) Viewed 10514 times

Ready now the finish:

IMG_1966.JPG (174.73 KiB) Viewed 10514 times

IMG_1969.JPG (167.74 KiB) Viewed 10514 times

IMG_1970.JPG (189.92 KiB) Viewed 10514 times

IMG_1978.JPG (156.42 KiB) Viewed 10514 times

So easy and very, very low cost!

[sidnei]

show !!